新闻中心

品佳力推Nuvoton适用于PC应用的 Super IO IC–NCT6106D

 2014-05-28

【产品介绍】
NCT6106D是目前针对工业PC应用的输出输入芯片(Super I/O),其不但满足工业计算机应用上的各项需求,也已获得主要工业计算机厂商的认证与使用。NCT6106D可谓是目前工业计算机应用的最佳选择。  

【产品特色】
NCT6106D支持6组全功能序列阜,每一个序列阜支持128-byte FIFO、9-bit 模式、RS-485 数据流向控制、可选择外接14.7456MHz频率;NCT6106D考虑到工业计算机应用常处于严苛的环境,可在温度范围-40℃至+85℃内运作;可透过LPC接口将Port80译码;搭配新唐自行开发的Port80 Analyzer 应用程序或是Port80 Analyzer 侦错卡,可直接读取Port80值;搭配新唐自行开发的Health Manager软件,人性化的接口可节省调校NCT6106D的硬件监控(Hardware Monitor)效能至最佳状态时所耗费的资源。  

【系统方块图】




【产品特性
General
Meet LPC Spec. 1.1
‧Support LDRQ# (LPC DMA), SERIRQ (Serialized IRQ)
‧Integrated hardware monitor functions
‧Support DPM (Device Power Management), ACPI (Advanced Configuration and Power Interface)
‧Programmable configuration settings
‧Single 24-MHz or 48-MHz clock input
‧Support selective pins of 5 V tolerance

FDC
‧Variable write pre-compensation with track-selection capabil
‧Support vertical recording format
‧DMA-enable logic
‧16-byte data FIFO
‧Support floppy disk drives and tape drives
‧Detect all overrun and underrun conditions
‧Built-in address mark detection circuit to simplify the read ele
‧FDD anti-virus functions with software write protect and FDD inactive)
‧Support 3.5-inch or 5.25-inch floppy disk drives
‧Compatible with industry standard 82077
‧360K / 720K / 1.2M / 1.44M / 2.88M formats
‧250K, 300K, 500K, 1M, 2M bps data transfer rate
‧Support 3-mode FDD and its Windows driver

Interface
‧Uart/Parallel Port/KB controller/CIR & IR /GPIO /PECI / AMD SB-TSI /SMBus
‧Power Measurement
‧Support Power Consumption measurement
‧Fading LED driver control for power status and diagnostic indications

Advanced Power Saving
‧Advanced Sleep State Control to save motherboard Stand-by power consumption
‧Operation voltage
‧3.3 voltage

Package
‧128-pin LQFP

【应用范围
桌面计算机、计算机主板、计算机工作站等

若需任何产品详情, 请洽品佳集团Nuvoton产品线企划人员, 谢谢!