新聞中心

品佳為工業控制力推NXP LPC176x系列Cortex-M3微控制器

 2015-08-12

【產品圖檔】

【產品介紹】
LPC176x是一種適合嵌入式應用的Cortex-M3微控制器,具有高集成度和低功耗的特點,運行頻率為100 MHz。


【產品特色】
512 kB Flash記憶體、64 kB資料記憶體、乙太網MAC、USB 設備/主機/OTG、8通道DMA控制器、4個UART、2個CAN通道、3個SSP/SPI、3個I2C、I2S、8通道12位ADC、10位DAC、 電機控制PWM、正交編碼器介面、4個通用計時器、6輸出通用PWM、帶獨立電池供電的超低功耗即時時鐘以及多達70個通用I/O引腳。LPC1768與 100引腳的LPC2368 ARM7 MCU引腳相容


【產品規格

  • ARM Cortex-M3 processor, running at frequencies of up to 100 MHz
  • Up to 512 kB on-chip flash programming memory
  • Up to 64 kB On-chip SRAM
  • In-System Programming (ISP) and In-Application Programming (IAP)
  • Eight channel General Purpose DMA controller (GPDMA)
  • Ethernet MAC with RMII interface and dedicated DMA controller
  • USB 2.0 full-speed device/Host/OTG controller
  • Four UARTs with fractional baud rate generation, internal FIFO, and DMA support
  • CAN 2.0B controller with two channels
  • SPI controller with synchronous, serial, full duplex communication
  • Two SSP controllers with FIFO and multi-protocol capabilities
  • Three enhanced I2C bus interfaces
  • I2S (Inter-IC Sound) interface
  • 70 General Purpose I/O (GPIO) pins with configurable pull-up/down resistors
  • 12-bit/8-ch Analog/Digital Converter (ADC) with conversion rates up to 200 kHz
  • 10-bit Digital/Analog Converter (DAC) with dedicated conversion timer and DMA
  • Four general purpose timers/counters
  • One motor control PWM with support for three-phase motor control
  • Quadrature encoder interface that can monitor one external quadrature encoder
  • One standard PWM/timer block with external count input
  • Low power RTC with a separate power domain and dedicated oscillator
  • WatchDog Timer (WDT)
  • ARM Cortex-M3 system tick timer, including an external clock input option
  • Repetitive interrupt timer provides programmable and repeating timed interrupts
  • Each peripheral has its own clock divider for further power savings
  • Standard JTAG test/debug interface for compatibility with existing tools
  • Integrated PMU (Power Management Unit)
  • Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deep power-down
  • Single 3.3 V power supply (2.4 V to 3.6 V)
  • Four external interrupt inputs configurable as edge/level sensitive
  • Non-maskable Interrupt (NMI) input
  • Wake-up Interrupt Controller (WIC)
  • Processor wake-up from Power-down mode via any interrupt
  • Brownout detect with separate threshold for interrupt and forced reset
  • Power-On Reset (POR)
  • Crystal oscillator with an operating range of 1 MHz to 25 MHz
  • 4 MHz internal RC oscillator trimmed to 1 % accuracy
  • Code Read Protection (CRP) with different security levels
  • Unique device serial number for identification purposes

【產品應用】

  • 電子計量
  • 照明
  • 工業網路
  • 報警系統
  • 白色家電
  • 電機控制

 若需任何產品詳情, 請洽以下品佳集團NXP產品線企劃人員,
或造訪品佳集團網站 http://www.sacg.com.tw/ , 謝謝!