新聞中心

品佳集團推出 Bosch+Grain Media+NXP 遠端醫療整合方案

 2013-05-08

近年人口老化情況逐年嚴重,醫療需求逐年增加,可預期未來遠距醫療需求也將隨之大量增加。透過監控系統執行遠端醫療照護可降低護理成本,也改變了現行護理模式,這將促使遠端監控應用在未來持續成長。

品佳集團推出Grain Media SOC元件+Bosch G-Sensor + NXP IEEE802.15.4 Wireless Microcontroller遠端醫療照護解決方案。

一、應用示意圖(Application Scenario)

SACG Remote Medical Solutions Application Scenario

二、應用方塊圖(Application Block Diagram)

SACG Remote Medical Solutions Application Block Diagram

 

三、 品佳集團遠端醫療照護方案推薦IC介紹

1. Grain Media GM8125/26/28 –業界最高效能、整合度的IPCAM晶片

GM8125/26/28 方塊圖:

Grain Media GM8125/26/28 方塊圖

 

功能與特色:

Grain Media GM8125/26/28 功能與特色

Comparsion Table of GM8125/GM8126/GM8128


2. Bosch G-Sensor (BMA222E, BMA250E)

Bosch G-Sensor (BMA222E)

Bosch G-Sensor (BMA222E)

Bosch G-Sensor (BMA250E)

Bosch G-Sensor (BMA250E)

3. NXP IEEE802.15.4 Wireless Microcontroller (JN516x)

Block Diagram

NXP IEEE802.15.4 Wireless Microcontroller (JN516x) Block Diagram

Benefits
• Single chip device to run stack and application
• Very low current solution for long battery life – over 10 yrs
• Supports multiple network stacks
• Highly featured 32-bit RISC CPU for high performance and low power
• System BOM is low in component count and cost
• Flexible sensor interfacing options

Features: Radio
• 2.4GHz IEEE802.15.4 compliant
• 128-bit AES security processor
• MAC accelerator with packet formatting, CRCs, address check, auto-acks, timers
• Integrated ultra low power sleep oscillator – 0.6mA
• 2.0V to 3.6V battery operation
• Deep sleep current 0.12μA (Wake-up from IO)
• <$0.15 external component cost
• RX current 17mA , TX 15mA
• Receiver sensitivity -95dBm
• Transmit power 2.5dBm
• Time of Flight engine for ranging
• Antenna Diversity (Auto RX)

Features: Microcontroller
• 32-bit RISC CPU, 1 to 32MHz clock speed
• Variable instruction width for high coding efficiency
• Multi-stage instruction pipeline
• JN5161: 64kB/8kB/4kB
• JN5164: 160kB/32kB/4kB
• JN5168: 256kB/32kB/4kB (Flash/RAM/EEPROM)
• Data EEPROM with guaranteed 100k write operations.
• RF4CE, JenNet-IP, ZigBee SE and ZigBee Light Link stacks
• 2-wire I2C compatible serial interface. Can operate as either master or slave
• 5xPWM (4x timer & 1 timer/counter)
• 2 low power sleep counters
• 2x UART
• SPI Master & Slave port, 3 selects
• Supply voltage monitor with 8 programmable thresholds
• 4-input 10-bit ADC, comparator
• Battery and temperature sensors
• Watchdog & Brown Out Reset
• Up to 20 Digital IO Pins (DIO)
• Infra-red remote control transmitter

若需品佳集團遠端醫療照護方案產品詳情, 請洽以下品佳集團Bosch、Grain Media、NXP產品線企劃人員, 謝謝!