新闻中心

品佳力推 Nuvoton 适合工业计算器及周边应用的 Super IO IC–NCT6106D

 2014-11-26

【方案介绍】
NCT6106D是目前针对工业PC应用的输出输入芯片(Super I/O),其不但满足工业计算机应用上的各项需求,也已获得主要工业计算机厂商的认证与使用。NCT6106D可谓是目前工业计算机应用的最佳选择。

【方案特色
NCT6106D支持6组全功能序列阜,每一个序列阜支持128-byte FIFO、9-bit 模式、RS-485 数据流向控制、可选择外接14.7456MHz频率;NCT6106D考虑到工业计算机应用常处于严苛的环境,可在温度范围-40℃至+85℃内运作;可透过LPC接口将Port80译码;搭配新唐自行开发的Port80 Analyzer 应用程序或是Port80 Analyzer 侦错卡,可直接读取Port80值;搭配新唐自行开发的Health Manager软件,人性化的接口可节省调校NCT6106D的硬件监控(Hardware Monitor)效能至最佳状态时所耗费的资源。

【系统方块图】


【方案图片】

 

【方案特性】
General
• Meet LPC Spec. 1.1
• Support LDRQ# (LPC DMA), SERIRQ (Serialized IRQ)
• Integrated hardware monitor functions
• Support DPM (Device Power Management), ACPI (Advanced Configuration and Power Interface)
• Programmable configuration settings
• Single 24-MHz or 48-MHz clock input
• Support selective pins of 5 V tolerance

FDC
• Variable write pre-compensation with track-selection capabil
• Support vertical recording format
• DMA-enable logic
• 16-byte data FIFO
• Support floppy disk drives and tape drives
• Detect all overrun and underrun conditions
• Built-in address mark detection circuit to simplify the read ele
• FDD anti-virus functions with software write protect and FDD inactive)
• Support 3.5-inch or 5.25-inch floppy disk drives
• Compatible with industry standard 82077
• 360K / 720K / 1.2M / 1.44M / 2.88M formats
• 250K, 300K, 500K, 1M, 2M bps data transfer rate
• Support 3-mode FDD and its Windows driver

Interface
• Uart/Parallel Port/KB controller/CIR & IR /GPIO /PECI / AMD SB-TSI /SMBus

Power Measurement
• Support Power Consumption measurement
• Fading LED driver control for power status and diagnostic indications

Advanced Power Saving
• Advanced Sleep State Control to save motherboard Stand-by power consumption

Operation voltage
• 3.3 voltage

Package
•128-pin LQFP

【应用范围】
NCT6016D适合应用于工业计算器、桌上型电脑、电脑主板、电脑工作站等